1. Run NovaLCT-Mars, move the cursor over the  Advanced User Login (A) and click the button.

2. Login with the password “ admin ”.

3. Click on the  Brightness button.

4. Select the  Automatically Adjustment mode, and then click the  Wizard Settings button.

5. Select the  Adjust by Light Sensor mode, and then go the  Next step.

6. You should finish the Light Sensor Configuration before this step, if not please search ‘Light Sensor Configuration’ on

NovaStar website www.novastar.tech. Click  Refresh to update the  Environment Brightness

7. Click  Light Sensor Test to check if the Light Sensor is working normally and if the LED Screen is responding to the Light

Sensor normally. Click  Stop Test when you need.

8. Click  Fast Section Division to mapping the  Environment Brightness with the  Screen Brightness . Input the 

Upper Limit and  Lower Limit mapping rules according to the installation environment of your LED Screen, and
set the total amount of the brightness levels via moving the Slider. Click OK to complete the mapping.

9. Click  Finish to save previous mapping rule.

10. Here you can click  Light Sensor Configuration to go back to Step 8 to edit the mapping rule you just added,

if no need, click  Save  and close this window to finish this part.